Watch Winder Settings for IWC: TPD and Direction
Set an IWC winder to the 650–800 TPD band and check the direction before anything else. The 4 automatic calibres listed here need between 160 and 460 TPD to hold a full wind, because the reserves run 42–120 hours.
IWC TPD and direction by calibre
| Calibre | Type | Reserve (h) | Beat (vph) | Direction | Min TPD | Recommended | Note |
|---|---|---|---|---|---|---|---|
| Calibre 79320 (7750 base) | Automatic | 44 | 28,800 | Clockwise | 440 | 800–1000 | Chronograph |
| Calibre 30110 | Automatic | 42 | 28,800 | Bidirectional | 460 | 650–800 | ETA 2892 base |
| Calibre 32111 | Automatic | 120 | 28,800 | Bidirectional | 160 | 650–800 | Five-day in-house |
| Calibre 69380 | Automatic | 46 | 28,800 | Bidirectional | 420 | 650–800 | In-house chronograph |
Rows marked n/a are hand-wound or quartz. A winder adds nothing to either: no rotor to turn, or no mainspring to hold. Full method and the other 38 brands are in the TPD settings database.
What makes IWC different
IWC has the widest spread in the database. The 32111 runs five days (120 h) and needs 160 TPD; the 69380 chronograph runs 46 hours and needs 420; the 79320 is a 7750 base that winds clockwise only.
Three different answers inside one brand, so check the specific calibre before touching the setting — and note that the 79320 also carries the higher 800–1000 band.
Setting an IWC winder in four steps
- Set the direction first. Bidirectional for the automatics on this page, with the exceptions noted in the table. Direction is the setting that silently does nothing when it is wrong.
- Wind to full on the published band. Run 650–800 TPD for 48 hours to fill the mainspring from stopped. Do not start at the calculated minimum — that figure holds a wind, it does not build one.
- Check the power reserve. After 48 hours, take the watch off and let it run down. Full reserve means the setting works. Short means raise TPD or reverse the direction.
- Back the setting down if you want less wear. Once the reserve is confirmed, the calculated minimum (160–460 TPD) holds the watch at full wind with fewer cycles. This is optional, not required.
Winders that can be set to these numbers
Per-rotor TPD and direction programming is the only requirement — a winder with a single fixed programme cannot follow the table above.
- Premium Intelligent 4 Watch Winder with Touch Control
- Silent Watch Winder Microfiber Leather with LCD Touch Screen(black+red) for Men
- LCD Touch Screen 12 Watch Winder for 12 Automatic Watches
Frequently asked questions
What TPD should I set for an IWC watch winder?
650–800 TPD is the band to start with. The calculated minimum — the turns that replace one day of running — is 160–460 TPD for the calibres on this page. Start on the band for 48 hours to fill a stopped watch, then back the setting down towards the calculated figure if you want less wear.
Which direction should an IWC winder turn?
Not the same for every calibre. Most are bidirectional, but Calibre 79320 (clockwise) wind in one direction only. Wrong direction means the rotor freewheels and the watch runs down while the winder turns.
Can I leave an IWC on the winder permanently?
Yes, at a setting near the calculated minimum. IWC reserves here run 42–120 h, so 160–460 TPD holds the watch at full wind without cycling the mainspring more than necessary. Check the reserve after 48 hours before settling on a permanent setting.
Is a higher TPD better for an IWC?
No. TPD only has to replace what the movement consumes. On a 120-hour IWC calibre that is 160 TPD; running 800 or 1000 keeps the mainspring at full tension and cycles it more often for no gain.
Where do these IWC figures come from?
Reserve and beat rate are manufacturer-published figures for each calibre; direction and the recommended band are published workshop practice. Only the Minimum TPD column is calculated: 24 ÷ reserve hours × 800, rounded. Full method and the CSV download are on the TPD settings database.
Source, version and citation
Figures are from Aurawinder’s Watch Winder TPD Settings Database, version 2.0, updated 9 November 2026, released under CC BY 4.0. The minimum TPD column is calculated as round(24 ÷ reserve hours × 800, -1); every other figure is published data. Reuse is allowed with attribution.
Cite this data
CC BY 4.0 · free to reuse · keep the linkAurawinder. "IWC Watch Winder TPD Settings," database version 2.0, updated 9 November 2026. https://www.aurawinder.com/tpd/iwc/ (CC BY 4.0).
<a href="https://www.aurawinder.com/tpd/iwc/">Aurawinder TPD Database: IWC</a>
Found an error, or an IWC calibre that should be here? Tell us — corrections are logged in the database changelog.