Watch Winder Settings for Panerai: TPD and Direction

Set a Panerai winder to the 650–800 TPD band and check the direction before anything else. The 1 automatic calibre listed here need between 270 and 270 TPD to hold a full wind, because the reserve is 72 hours. The 2 hand-wound calibres gain nothing from a winder.

Recommended band650–800 TPD
Calculated minimum270 TPD
DirectionBidirectional
Coverage1 automatic · 2 hand-wound · 72 h

Panerai TPD and direction by calibre

Calibre Type Reserve (h) Beat (vph) Direction Min TPD Recommended Note
P.9000 / P.9010 Automatic 72 28,800 Bidirectional 270 650–800 —
P.5000 Manual 192 21,600 n/a — n/a Eight-day hand-wound — a winder cannot help
P.3000 Manual 72 21,600 n/a — n/a Three-day hand-wound

Rows marked n/a are hand-wound or quartz. A winder adds nothing to either: no rotor to turn, or no mainspring to hold. Full method and the other 38 brands are in the TPD settings database.

What makes Panerai different

Only the automatic Panerai rows take a TPD setting. The P.9000 / P.9010 runs 72 hours and needs 270.

The P.5000 is an eight-day hand-wound and the P.3000 a three-day hand-wound — a winder cannot help either, and the eight-day reserve makes them the watches most often left on a winder by mistake.

Setting a Panerai winder in four steps

  1. Set the direction first. Bidirectional for the automatics on this page. Direction is the setting that silently does nothing when it is wrong.
  2. Wind to full on the published band. Run 650–800 TPD for 48 hours to fill the mainspring from stopped. Do not start at the calculated minimum — that figure holds a wind, it does not build one.
  3. Check the power reserve. After 48 hours, take the watch off and let it run down. Full reserve means the setting works. Short means raise TPD or reverse the direction.
  4. Back the setting down if you want less wear. Once the reserve is confirmed, the calculated minimum (270 TPD) holds the watch at full wind with fewer cycles. This is optional, not required.

Winders that can be set to these numbers

Per-rotor TPD and direction programming is the only requirement — a winder with a single fixed programme cannot follow the table above.

Frequently asked questions

What TPD should I set for a Panerai watch winder?

650–800 TPD is the band to start with. The calculated minimum — the turns that replace one day of running — is 270–270 TPD for the calibres on this page. Start on the band for 48 hours to fill a stopped watch, then back the setting down towards the calculated figure if you want less wear.

Which direction should a Panerai winder turn?

Bidirectional. Every automatic Panerai calibre in this database winds in both directions, so either setting works. If the watch shows no gain after 48 hours, the problem is the TPD, not the direction.

Can I leave a Panerai on the winder permanently?

Yes, at a setting near the calculated minimum. Panerai reserves here run 72 h, so 270–270 TPD holds the watch at full wind without cycling the mainspring more than necessary. Check the reserve after 48 hours before settling on a permanent setting.

Do hand-wound Panerai models need a winder?

No. The P.5000, P.3000 are hand-wound: there is no rotor for the winder to turn, so it adds nothing. Keep them off the winder.

Where do these Panerai figures come from?

Reserve and beat rate are manufacturer-published figures for each calibre; direction and the recommended band are published workshop practice. Only the Minimum TPD column is calculated: 24 ÷ reserve hours × 800, rounded. Full method and the CSV download are on the TPD settings database.

Source, version and citation

Figures are from Aurawinder’s Watch Winder TPD Settings Database, version 2.0, updated 9 November 2026, released under CC BY 4.0. The minimum TPD column is calculated as round(24 ÷ reserve hours × 800, -1); every other figure is published data. Reuse is allowed with attribution.

Cite this data

CC BY 4.0 · free to reuse · keep the link
Plain text
Aurawinder. "Panerai Watch Winder TPD Settings," database version 2.0, updated 9 November 2026. https://www.aurawinder.com/tpd/panerai/ (CC BY 4.0).
HTML link
<a href="https://www.aurawinder.com/tpd/panerai/">Aurawinder TPD Database: Panerai</a>
Badge
Aurawinder TPD Database — Panerai
Need the numbers in a spreadsheet? Download the Panerai table as CSV · full database on the TPD settings database.

Found an error, or a Panerai calibre that should be here? Tell us — corrections are logged in the database changelog.

Further reading

Product was successfully added to your cart!