Watch Winder Settings for ETA / Valjoux: TPD and Direction

Set an ETA / Valjoux winder to the 800–1000 TPD band and check the direction before anything else. The 2 automatic calibres listed here need between 440 and 440 TPD to hold a full wind, because the reserve is 44 hours.

Recommended band800–1000 TPD
Calculated minimum440 TPD
DirectionClockwise
Coverage2 automatic · 44 h

ETA / Valjoux TPD and direction by calibre

Calibre Type Reserve (h) Beat (vph) Direction Min TPD Recommended Note
7750 Automatic 44 28,800 Clockwise 440 800–1000 Unidirectional — direction matters
7753 Automatic 44 28,800 Clockwise 440 800–1000 7750 with a minute-counter pusher

Rows marked n/a are hand-wound or quartz. A winder adds nothing to either: no rotor to turn, or no mainspring to hold. Full method and the other 38 brands are in the TPD settings database.

What makes ETA / Valjoux different

The 7750 family is the exception to the bidirectional rule. Both calibres here wind in one direction only, clockwise, on a 44-hour reserve.

Run a 7750 anticlockwise and the rotor freewheels: the winder turns all day and the watch still runs down. The published band is also higher, 800–1000 TPD, with a 440 TPD calculated floor.

Setting an ETA / Valjoux winder in four steps

  1. Set the direction first. Clockwise for the automatics on this page. Direction is the setting that silently does nothing when it is wrong.
  2. Wind to full on the published band. Run 800–1000 TPD for 48 hours to fill the mainspring from stopped. Do not start at the calculated minimum — that figure holds a wind, it does not build one.
  3. Check the power reserve. After 48 hours, take the watch off and let it run down. Full reserve means the setting works. Short means raise TPD or reverse the direction.
  4. Back the setting down if you want less wear. Once the reserve is confirmed, the calculated minimum (440 TPD) holds the watch at full wind with fewer cycles. This is optional, not required.

Winders that can be set to these numbers

Per-rotor TPD and direction programming is the only requirement — a winder with a single fixed programme cannot follow the table above.

Frequently asked questions

What TPD should I set for an ETA / Valjoux watch winder?

800–1000 TPD is the band to start with. The calculated minimum — the turns that replace one day of running — is 440–440 TPD for the calibres on this page. Start on the band for 48 hours to fill a stopped watch, then back the setting down towards the calculated figure if you want less wear.

Which direction should an ETA / Valjoux winder turn?

Bidirectional. Every automatic ETA / Valjoux calibre in this database winds in both directions, so either setting works. If the watch shows no gain after 48 hours, the problem is the TPD, not the direction.

Can I leave an ETA / Valjoux on the winder permanently?

Yes, at a setting near the calculated minimum. ETA / Valjoux reserves here run 44 h, so 440–440 TPD holds the watch at full wind without cycling the mainspring more than necessary. Check the reserve after 48 hours before settling on a permanent setting.

Is a higher TPD better for an ETA / Valjoux?

No. TPD only has to replace what the movement consumes. On a 44-hour ETA / Valjoux calibre that is 440 TPD; running 800 or 1000 keeps the mainspring at full tension and cycles it more often for no gain.

Where do these ETA / Valjoux figures come from?

Reserve and beat rate are manufacturer-published figures for each calibre; direction and the recommended band are published workshop practice. Only the Minimum TPD column is calculated: 24 ÷ reserve hours × 800, rounded. Full method and the CSV download are on the TPD settings database.

Source, version and citation

Figures are from Aurawinder’s Watch Winder TPD Settings Database, version 2.0, updated 9 November 2026, released under CC BY 4.0. The minimum TPD column is calculated as round(24 ÷ reserve hours × 800, -1); every other figure is published data. Reuse is allowed with attribution.

Cite this data

CC BY 4.0 · free to reuse · keep the link
Plain text
Aurawinder. "ETA / Valjoux Watch Winder TPD Settings," database version 2.0, updated 9 November 2026. https://www.aurawinder.com/tpd/eta-valjoux/ (CC BY 4.0).
HTML link
<a href="https://www.aurawinder.com/tpd/eta-valjoux/">Aurawinder TPD Database: ETA / Valjoux</a>
Badge
Aurawinder TPD Database — ETA / Valjoux
Need the numbers in a spreadsheet? Download the ETA / Valjoux table as CSV · full database on the TPD settings database.

Found an error, or an ETA / Valjoux calibre that should be here? Tell us — corrections are logged in the database changelog.

Further reading

Product was successfully added to your cart!