Watch Winder Settings for Miyota: TPD and Direction
Set a Miyota winder to the 650–800 TPD band and check the direction before anything else. The 4 automatic calibres listed here need between 460 and 480 TPD to hold a full wind, because the reserves run 40–42 hours.
Miyota TPD and direction by calibre
| Calibre | Type | Reserve (h) | Beat (vph) | Direction | Min TPD | Recommended | Note |
|---|---|---|---|---|---|---|---|
| 9015 | Automatic | 42 | 28,800 | Bidirectional | 460 | 650–800 | — |
| 9039 | Automatic | 42 | 28,800 | Bidirectional | 460 | 650–800 | No-date 9015 |
| 8215 | Automatic | 40 | 21,600 | Counter-clockwise | 480 | 650–800 | Unidirectional — verify before use |
| 8205 | Automatic | 40 | 21,600 | Counter-clockwise | 480 | 650–800 | Day-date version |
Rows marked n/a are hand-wound or quartz. A winder adds nothing to either: no rotor to turn, or no mainspring to hold. Full method and the other 38 brands are in the TPD settings database.
What makes Miyota different
Miyota is where direction actually bites. The 9015 and 9039 wind bidirectionally at 28,800 vph, but the 8215 and 8205 wind in one direction only — counter-clockwise.
Mixing an 8215 and a 9015 on the same winder is the classic mistake: one needs a direction setting and a 480 TPD floor, the other is happy either way.
Setting a Miyota winder in four steps
- Set the direction first. Bidirectional for the automatics on this page, with the exceptions noted in the table. Direction is the setting that silently does nothing when it is wrong.
- Wind to full on the published band. Run 650–800 TPD for 48 hours to fill the mainspring from stopped. Do not start at the calculated minimum — that figure holds a wind, it does not build one.
- Check the power reserve. After 48 hours, take the watch off and let it run down. Full reserve means the setting works. Short means raise TPD or reverse the direction.
- Back the setting down if you want less wear. Once the reserve is confirmed, the calculated minimum (460–480 TPD) holds the watch at full wind with fewer cycles. This is optional, not required.
Winders that can be set to these numbers
Per-rotor TPD and direction programming is the only requirement — a winder with a single fixed programme cannot follow the table above.
- Premium 4 Wooden Automatic Watch Winder Storage Box with LCD Touch Screen
- Luxury Double Watch Winder With Lcd Touch Screen
- Tiffany Blue Quad Watch Winder Jewelry Box
Frequently asked questions
What TPD should I set for a Miyota watch winder?
650–800 TPD is the band to start with. The calculated minimum — the turns that replace one day of running — is 460–480 TPD for the calibres on this page. Start on the band for 48 hours to fill a stopped watch, then back the setting down towards the calculated figure if you want less wear.
Which direction should a Miyota winder turn?
Not the same for every calibre. Most are bidirectional, but 8215 (counter-clockwise), 8205 (counter-clockwise) wind in one direction only. Wrong direction means the rotor freewheels and the watch runs down while the winder turns.
Can I leave a Miyota on the winder permanently?
Yes, at a setting near the calculated minimum. Miyota reserves here run 40–42 h, so 460–480 TPD holds the watch at full wind without cycling the mainspring more than necessary. Check the reserve after 48 hours before settling on a permanent setting.
Is a higher TPD better for a Miyota?
No. TPD only has to replace what the movement consumes. On a 42-hour Miyota calibre that is 460 TPD; running 800 or 1000 keeps the mainspring at full tension and cycles it more often for no gain.
Where do these Miyota figures come from?
Reserve and beat rate are manufacturer-published figures for each calibre; direction and the recommended band are published workshop practice. Only the Minimum TPD column is calculated: 24 ÷ reserve hours × 800, rounded. Full method and the CSV download are on the TPD settings database.
Source, version and citation
Figures are from Aurawinder’s Watch Winder TPD Settings Database, version 2.0, updated 9 November 2026, released under CC BY 4.0. The minimum TPD column is calculated as round(24 ÷ reserve hours × 800, -1); every other figure is published data. Reuse is allowed with attribution.
Cite this data
CC BY 4.0 · free to reuse · keep the linkAurawinder. "Miyota Watch Winder TPD Settings," database version 2.0, updated 9 November 2026. https://www.aurawinder.com/tpd/miyota/ (CC BY 4.0).
<a href="https://www.aurawinder.com/tpd/miyota/">Aurawinder TPD Database: Miyota</a>
Found an error, or a Miyota calibre that should be here? Tell us — corrections are logged in the database changelog.