Watch Winder Settings for Orient: TPD and Direction
Set an Orient winder to the 650–800 TPD band and check the direction before anything else. The 1 automatic calibre listed here need between 480 and 480 TPD to hold a full wind, because the reserve is 40 hours.
Orient TPD and direction by calibre
| Calibre | Type | Reserve (h) | Beat (vph) | Direction | Min TPD | Recommended | Note |
|---|---|---|---|---|---|---|---|
| F6922 | Automatic | 40 | 21,600 | Bidirectional | 480 | 650–800 | In-house; 21,600 vph |
| F6722 | Automatic | 40 | 21,600 | Bidirectional | 480 | 650–800 | Hacking and hand-winding; Bambino/Mako 40 |
Rows marked n/a are hand-wound or quartz. A winder adds nothing to either: no rotor to turn, or no mainspring to hold. Full method and the other 38 brands are in the TPD settings database.
What makes Orient different
Orient’s in-house F6922 is a 40-hour automatic at 21,600 vph with a bidirectional rotor.
480 TPD floor — high, because the reserve is short and the beat is slow.
Setting an Orient winder in four steps
- Set the direction first. Bidirectional for the automatics on this page. Direction is the setting that silently does nothing when it is wrong.
- Wind to full on the published band. Run 650–800 TPD for 48 hours to fill the mainspring from stopped. Do not start at the calculated minimum — that figure holds a wind, it does not build one.
- Check the power reserve. After 48 hours, take the watch off and let it run down. Full reserve means the setting works. Short means raise TPD or reverse the direction.
- Back the setting down if you want less wear. Once the reserve is confirmed, the calculated minimum (480 TPD) holds the watch at full wind with fewer cycles. This is optional, not required.
Winders that can be set to these numbers
Per-rotor TPD and direction programming is the only requirement — a winder with a single fixed programme cannot follow the table above.
- Premium 4 Wooden Automatic Watch Winder Storage Box with LCD Touch Screen
- Luxury Double Watch Winder With Lcd Touch Screen
- Tiffany Blue Quad Watch Winder Jewelry Box
Frequently asked questions
What TPD should I set for an Orient watch winder?
650–800 TPD is the band to start with. The calculated minimum — the turns that replace one day of running — is 480–480 TPD for the calibres on this page. Start on the band for 48 hours to fill a stopped watch, then back the setting down towards the calculated figure if you want less wear.
Which direction should an Orient winder turn?
Bidirectional. Every automatic Orient calibre in this database winds in both directions, so either setting works. If the watch shows no gain after 48 hours, the problem is the TPD, not the direction.
Can I leave an Orient on the winder permanently?
Yes, at a setting near the calculated minimum. Orient reserves here run 40 h, so 480–480 TPD holds the watch at full wind without cycling the mainspring more than necessary. Check the reserve after 48 hours before settling on a permanent setting.
Is a higher TPD better for an Orient?
No. TPD only has to replace what the movement consumes. On a 40-hour Orient calibre that is 480 TPD; running 800 or 1000 keeps the mainspring at full tension and cycles it more often for no gain.
Where do these Orient figures come from?
Reserve and beat rate are manufacturer-published figures for each calibre; direction and the recommended band are published workshop practice. Only the Minimum TPD column is calculated: 24 ÷ reserve hours × 800, rounded. Full method and the CSV download are on the TPD settings database.
Source, version and citation
Figures are from Aurawinder’s Watch Winder TPD Settings Database, version 2.0, updated 9 November 2026, released under CC BY 4.0. The minimum TPD column is calculated as round(24 ÷ reserve hours × 800, -1); every other figure is published data. Reuse is allowed with attribution.
Cite this data
CC BY 4.0 · free to reuse · keep the linkAurawinder. "Orient Watch Winder TPD Settings," database version 2.0, updated 9 November 2026. https://www.aurawinder.com/tpd/orient/ (CC BY 4.0).
<a href="https://www.aurawinder.com/tpd/orient/">Aurawinder TPD Database: Orient</a>
Found an error, or an Orient calibre that should be here? Tell us — corrections are logged in the database changelog.